SainSonic STC-1000 All-Purpose Temperature Controller with Sensor Probe
|Price:||CDN$ 30.24 & FREE Shipping. Details|
Fulfilment by Amazon (FBA) is a service we offer sellers that lets them store their products in Amazon's fulfilment centres, and we directly pack, ship, and provide customer service for these products. Something we hope you'll especially enjoy: FBA products qualify for FREE Shipping
If you're a seller, Fulfilment by Amazon can help you increase your sales. We invite you to learn more about Fulfilment by Amazon .
- Switch the modes between cool and heat
- Control temperature by setting the temperature setting value and the difference value
- Temperature calibration
- Refrigerating control output delay protection
- Alarm when temperature exceeds temperature limit or when sensor error
Frequently Bought Together
Customers Who Bought This Item Also Bought
Switch the modes between cool and heat; Control temperature by setting the temperature setting value and the difference value; Temperature calibration; Refrigerating control output delay protection; Alarm when temperature exceeds temperature limit or when sensor error.
What Other Items Do Customers Buy After Viewing This Item?
Top Customer Reviews
Once it's powered, hold the S button for 3 seconds until it displays F1 then keep holding the S key while you adjust the desired temperature.
Lastly, you need to press the power button once you've programmed it or it will forget the settings and go back to default.
I noticed it uses the same layout as the original ST-1000 so you could program ST1000+ software with a pickit or arduino. If a homebrewer needs this.
As many have mentioned the instructions are woefully translated but it's easy enough to wire. The point has been made that you need to hold "s" for 3 sec or more to get into setup and once you've found the variable you want to alter, press and hold the "s" and the up/down arrow to adjust. After setting remember to press the pwr button to store the new setting. The set temp is the centre of the range with the differential either side of that for starting heating/cooling.
The relays are only good for 10A and my old freezer spikes over that when the compressor starts (I think that fried my last temp controller which had the same limit) so now I've wired a solid state ac-ac relay that will handle 20A and it's happy as Larry (so far).
The alarm is only triggered if there is an open or a short circuit on the temp probe or if the sensed temp is out of limits for the controller (i.e. you can't set an alarm temp).
Most recent customer reviews
Works perfectly in a custom fermentation chamber for homebrewing. It controls a mini fridge and a heating belt and keeps my beer within a degree of target temp when fermenting 5... Read morePublished 6 days ago by Joseph Hollebakke
Exactly as pictured and described. Delivered in timely mannerPublished 3 months ago by Amazon Customer
This item was very small and not how I expected it to look.Published 5 months ago by Amazon Customer
Is cheap and gets the job done. As far as I can tell, and as I have it currently wired up, it only does either heating or cooling. Read morePublished 5 months ago by Tyler Acorn